Nissan Juke Service and Repair Manual : Ignition timing
Description
This describes how to check the ignition timing. For the actual procedure, follow the instructions in “BASIC INSPECTION”.
Special Repair Requirement
1.CHECK IGNITION TIMING
1. Attach timing light to the ignition coil No.4 harness.
2. Check ignition timing.
1 : Timing indicator
>> INSPECTION END
Idle speed
Description This describes how to check the idle speed. For the actual procedure, follow the instructions in “BASIC INSPECTION”. Special Repair Requirement 1.CHECK IDLE SPEED With CONSULT-III ...Evaporative emission system
Inspection 1. Visually inspect EVAP vapor lines for improper attachment and for cracks, damage, loose connections, chafing and deterioration. 2. Check EVAP canister as follows: a. Block port (B) ...Other materials:
U1010 control unit (CAN)
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent malfunction
detection ability.
Many electronic control units are equipped onto a vehicle, and ...
On is not displayed when pressing rear window defogger
switch but it is operated
Diagnosis Procedure
1.CHECK MULTI DISPLAY UNIT FUNCTION
Check that the multi display unit is operating normally.
• Auto A/C (4WD models). Refer to HAC-44, "Work Flow".
• Auto A/C (2WD models). Refer to HAC-135, "Work Flow".
Is the inspection result normal?
YES >> ...
P0087 fuel pump
DTC Logic
DTC DETECTION LOGIC
NOTE:
• Conditions for applying the diagnostic procedure to the stored DTCs:
The DTC becomes present during the first 30 seconds after the engine starts.
• In low ambient temperature conditions, diagnostic cannot make difference
between a normal long engine
st ...