Nissan Juke Service and Repair Manual : Ignition position warning function does not operate
Diagnosis Procedure
1.CHECK DTC WITH BCM
Check that DTC is not detected with BCM.
Is the inspection result normal? YES >> GO TO 2.
NO >> Refer to BCS-67, "DTC Index".
2.CHECK POWER DOOR LOCK OPERATION
Check power door lock operation.
Does door lock/unlock with driver side door lock knob and door key cylinder? YES >> GO TO 3.
NO >> Refer to DLK-276, "ALL DOOR : Diagnosis Procedure".
3.CHECK DOOR SWITCH
Check door switch.
Refer to DLK-258, "Component Function Check".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace the malfunctioning parts.
4.CHECK UNLOCK SENSOR
Check unlock sensor.
Refer to DLK-270, "Component Function Check".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace the malfunctioning parts.
5.REPLACE BCM
1. Replace BCM. Refer to BCS-93, "Removal and Installation".
2. Confirm the operation after replacement.
Is the result normal? YES >> INSPECTION END
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Door does not lock/unlock with intelligent key
Diagnosis Procedure 1.CHECK DTC WITH BCM AND TCM Check that DTC is not detected with BCM and TCM. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-67, "D ...ANTI-HIJACK function does not operate
Diagnosis Procedure 1.CHECK “DOOR LOCK–UNLOCK SET” SETTING IN “WORK SUPPORT” 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR LOCK-UNLOCK SET” in “WORK SUPPORT” mode. 3. Check “DO ...Other materials:
Normal operating condition
INFORMATION DISPLAY
INFORMATION DISPLAY : Description
AMBIENT TEMPERATURE
The displayed ambient temperature on the information display may differ from
the actual temperature because
it is a corrected value calculated from the ambient sensor signal by the
combination meter. Refer to MWI-16,
...
B2581, B2582 intake sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC is displayed along with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to HAC-
141, "DTC Logic".
• If DTC is displayed along with DTC U1010, first perform the trouble diagnosis
for DTC U1010. HAC-142,
"DTC Log ...
Precaution
Precautions for Suspension
• When installing rubber bushings, the final tightening must be carried out
under unladen conditions with tires
on ground. Spilled oil might shorten the life of rubber bushings. Be sure to
wipe off any spilled oil.
- Unladen conditions mean that fuel, engine coolant ...