Nissan Juke Service and Repair Manual : Idle neutral control learning
Description
TCM corrects an individual difference in clutch clearance of the transaxle assembly by performing the idle neutral control learning and enables accurate idle neutral control.
Therefore, it is required to perform idle neutral control learning after the following work is performed.
• Replacement of TCM
• Replacement of control valve
• Replacement of transaxle assembly
Procedure
1.PREPARATION BEFORE WORK
With CONSULT-III
1. Start the engine.
CAUTION:
Never drive the vehicle.
2. Select “DATA MONITOR” in “TRANSMISSION”.
3. Select “ATFTEMP COUNT”.
Is “ATFTEMP COUNT” 47 [equivalent to 20°C (68°F)] or more? YES >> GO TO 2.
NO >> 1. Warm up the transaxle assembly until “ATFTEMP COUNT” reaches “47” [equivalent to 20°C(68°F)] or more.
2. GO TO 2.
2.PERFORM IDLE NEUTRAL CONTROL LEARNING
CAUTION:
Perform this work with the flat road. (± 2.6 %or less)
1. Shift the selector lever to “D” position.
2. Drive the vehicle at the 8 km/h (5 MPH) or more.
3. Brake pedal is depressed and stop the vehicle.
4. Maintain the following conditions for 30 seconds or more.
Stop lamp switch : ON Accelerator pedal position sensor : OFF Engine speed : 475 – 700 rpm Electrical load : Not applied*
*: Rear window defogger switch, air conditioner switch, lighting switch, etc. are OFF. Steering wheel is straight ahead. (Parking lamp ON is possible) 5. Brake pedal is released and drive the vehicle.
6. Perform steps 1 and 2 again. (one time)
>> INSPECTION END
Calibration of decel G sensor
Description
TCM stores calibration data (inherent characteristic value) of G sensor to
provide accurate control. Therefore,
it is required to perform calibration of G sensor after the following wo ...
CVT fluid
Inspection
CHECKING CVT FLUID
The fluid level should be checked with the fluid warmed up to 50 to 80°C (122
to 176°F). The fluid level check
procedure is as follows:
1. Check for fluid leakage.
...
Other materials:
Brake pedal
Exploded View
WITHOUT ESP
1. Clevis pin
2. Brake pedal assembly
3. Brake pedal pad
4. Stop lamp switch
5. Clip
6. Snap pin
: Apply multi-purpose grease.
: N·m (kg-m, ft-lb)
WITH ESP
1. Clevis pin
2. Brake pedal assembly
3. Brake pedal pad
4. Brake switch/brake pedal position
...
On is not displayed when pressing rear window defogger
switch but it is operated
Diagnosis Procedure
1.CHECK MULTI DISPLAY UNIT FUNCTION
Check that the multi display unit is operating normally.
• Auto A/C (4WD models). Refer to HAC-44, "Work Flow".
• Auto A/C (2WD models). Refer to HAC-135, "Work Flow".
Is the inspection result normal?
YES >> ...
System description
COMPONENT PARTS
Circuit Breaker
The PTC thermistor generates heat in response to current flow. The
temperature (and resistance) of the thermistor element varies with
current flow. Excessive current flow will cause the element's temperature
to rise. When the temperature reaches a specified level ...
