Nissan Juke Service and Repair Manual : HR16DE : Exploded View
REMOVAL
1. Cylinder block
2. “B” terminal harness
3. “S” terminal harness
4. Starter motor
: Vehicle front
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
DISASSEMBLY
Type: M000T32172ZE
1. “M” terminal nut
2. Magnetic switch assembly
3. Adjusting plate
4. Metal FR
5. Gear case
6. Yoke
7. Armature
8. Brush holder assembly
9. Metal RR
10. Rear cover
11. Through bolt
12. Planetary gear
13. Gear shaft
14. Packing
15. Plate
16. Shift lever
17. Stopper ring
18. Stopper
19. Pinion assembly
20. Internal gear
21. Packing
: N·m (kg-m, in-lb)
: N·m (kg-m, ft-lb)
: High-temperature grease point
Removal and installation
STARTER MOTOR HR16DE ...HR16DE : Removal and Installation
REMOVAL 1. Disconnect the battery cable from the negative terminal. Refer to PG-124, "Removal and Installation". 2. Remove radiator reservoir tank. Refer to CO-17, "Exploded View&qu ...Other materials:
C1140 actuator relay system
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With CONSULT ...
The light reminder warning does not sound
Description
Light reminder warning chime does not sound even though headlamp is
illuminated.
Diagnosis Procedure
1.CHECK COMBINATION SWITCH (LIGHTING SWITCH) OPERATION
Check that the headlamps operate normally by operating the combination switch
(lighting switch).
Do they operate normally ...
Diagnosis system (ECM)
Diagnosis description
Diagnosis description : 1st Trip Detection
Logic and Two Trip Detection Logic
When a malfunction is detected for the first time, 1st trip DTC and 1st trip
Freeze Frame data are stored in the
ECM memory. The MIL will not illuminate at this stage. <1st trip>
If the s ...