Nissan Juke Service and Repair Manual : High-mounted stop lamp
Exploded View
1. High-mounted stop lamp 2. Seal packing
: N·m (kg-m, in-lb)
Removal and Installation
CAUTION:
Disconnect battery negative terminal or remove the fuse.
REMOVAL
1. Remove blind seal from back door inside.
CAUTION:
Be careful not to damage the blind seal, so that it can be reused.
2. Remove high-mounted stop lamp mounting nuts and connector.
3. Pull high-mounted stop lamp toward vehicle upside, and then remove high-mounted stop lamp.
INSTALLATION
Note the following item and then, install in the reverse order of removal.
CAUTION:
Seal packing cannot be reused.
Rear combination lamp
Exploded View REMOVAL 1. Grommet 2. Grommet 3. Rear combination lamp : Clip : N·m (kg-m, in-lb) DISASSEMBLY 1. Rear combination lamp housing assembly 2. Back-up lamp bulb 3. Harness ...License plate lamp
Exploded View 1. License plate lamp housing assembly 2. Blub 3. License plate lamp blub socket : Pawl Removal and Installation CAUTION: Disconnect battery negative terminal or remove the fu ...Other materials:
Front seat (4WD)
Exploded View
DRIVER SEAT
LHD models
1. Headrest
2. Headrest holder (locked)
3. Headrest holder (free)
4. Seatback assembly
(with heater seat only)
5. Inner lower cover
6. Seatback trim
(without heater seat only)
7. Seatback pad
(without heater seat only)
8. Seat belt buckle
9. A ...
P182F coupling temperature sensor left
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...
Door lock status indicator does not illuminate
Diagnosis Procedure
1.CHECK DOOR LOCK STATUS INDICATOR
Check door lock status indicator.
Refer to DLK-395, "Component Function Check".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONFIRM THE OPERATION
Conf ...