Nissan Juke Service and Repair Manual : Heater & Air Conditioning Control System Type 2
- How to use this manual
- Precaution
- System description
- Component parts
- System
- Operation
- Diagnosis system (A/C auto AMP.)
- Diagnosis system (BCM) (with intelligent key system)
- Diagnosis system (BCM) (without intelligent key system)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2578, B2579 In-vehicle sensor
- B257B, B257C ambient sensor
- B2581, B2582 intake sensor
- B2630, B2631 sunload sensor
- B2632, B2633 air mix door motor PBR
- B2636, B2637, B2638, B2639, B2654, B2655 mode door motor
- B263D, B263E, B263F intake door motor
- B27B0 A/C auto AMP.
- Power supply and ground circuit
- Door motor
- A/C on signal
- Blower fan on signal
- Blower motor
- Magnet clutch
- PTC heater
- Symptom diagnosis
- Removal and installation
Door motor
Exploded View LEFT SIDE 1. A/C unit assembly 2. Intake door lever 3. Intake door motor 4. Air mix door motor 5. Upper air mix door rod 6. Upper air mix door lever 7. Lower air mix door l ...How to use this manual
APPLICATION NOTICE Information Check the vehicle type to use the service information in this section. ...Other materials:
B1087 seat belt Pre-tensioner LH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Removal and Installation
REMOVAL
1. Remove rear propeller shaft assembly. Refer to DLN-121, "Removal and
Installation".
2. Remove rear drive shaft. Refer to RAX-17, "Removal and Installation".
3. Disconnect sub-harness connector (1).
4. Remove rear final drive breather hose.
5. Support rear final ...
P1554 battery current sensor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM COMPONENT FUNCTION CHECK
Perform component function check. Refer to EC-709, "Component Function
Check".
NOTE:
Use component function check to check the overall function of the battery
current sensor circuit. D ...