Nissan Juke Service and Repair Manual : Heater & Air Conditioning Control System Type 1
- How to use this manual
- Precaution
- System description
- Component parts
- System
- Operation
- Diagnosis system (A/C auto AMP.)
- Diagnosis system (BCM) (with intelligent key system)
- Diagnosis system (BCM) (without intelligent key system)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- U1000 can comm circuit
- U1010 control unit (CAN)
- B2578, B2579 In-vehicle sensor
- B257B, B257C ambient sensor
- B2581, B2582 intake sensor
- B2630, B2631 sunload sensor
- B27A0, B27A1 intake door motor
- B27A2, B27A3, B27A4, B27A5 air mix door motor
- B27A6, B27A7, B27A8, B27A9 mode door motor
- Power supply and ground circuit
- A/C on signal
- Blower fan on signal
- Blower motor
- Magnet clutch
- Symptom diagnosis
- Removal and installation
Service data and specifications (SDS
Compressor
Lubricant
Refrigerant
Engine Idling Speed
Refer to EC-449, "Idle Speed".
Belt Tension
Refer to EM-20, "Checking". ...
How to use this manual
APPLICATION NOTICE
Information
Check the vehicle type to use the service information in this section.
...
Other materials:
B1134 side air bag module LH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
C1609 vehicle speed signal
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn
ignition switch OFF and
wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
