Nissan Juke Owners Manual : Heated seats (if so equipped)
WARNING
Do not use or allow occupants to use the seat heater if you or the occupants cannot monitor elevated seat temperatures or have an inability to feel pain in body parts that contact the seat. Use of the seat heater by such people could result in serious injury.
CAUTION
• The battery could run down if the seat heater is operated while the engine is not running.
• Do not use the seat heater for extended periods or when no one is using the seat.
• Do not put anything on the seat which insulates heat, such as a blanket, cushion, seat cover, etc.
Otherwise, the seat may become overheated.
• Do not place anything hard or heavy on the seat or pierce it with a pin or similar object. This may result in damage to the heater.
• Any liquid spilled on the heated seat should be removed immediately with a dry cloth.
• When cleaning the seat, never use gasoline, thinner, or any similar materials.
• If any malfunctions are found or the heated seat does not operate, turn the switch off and have the system checked by a NISSAN dealer.
The seats are warmed by built-in heaters. The switches located on the center console can be operated independently of each other.
1. Start the engine.
2. Select heat range.
1 For high heat, push the HI (High) side of the switch.
2 For low heat, push the LO (Low) side of the switch.
The indicator light in the switch 3 will illuminate when the heater is on.
3. To turn off the heater, return the switch to the level position. Make sure the indicator light goes off.
The heater is controlled by a thermostat, automatically turning the heater on and off.
The indicator light will remain on as long as the switch is on.
When the vehicle’s interior is warmed, or before you leave the vehicle, be sure to turn off the switch.
Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the Vehicle Dynamic Control (VDC) system on
for most driving conditions.
If the vehicle is stuck in mud or snow, the VDC system reduces the engine output
to re ...
Clock (if so equipped)
The digital clock (in the audio unit) displays time when the ignition switch
is in the ACC or ON position. The clock ON or OFF mode can be selected. For details
of the digital clock in the NAVIGAT ...
Other materials:
Transmission range switch
Exploded View
1. Transmission range switch
2. Transaxle assem
Removal and Installation
REMOVAL
1. Remove battery. Refer to PG-124, "Removal and Installation".
2. Remove transmission range switch connector.
3. Remove control cable. Refer to TM-273, "Removal and Installation&q ...
AWD warning light
The AWD warning light located in the instrument panel illuminates when the ignition
switch is turned to the ON position. It turns off soon after the engine is started.
If any malfunction occurs in the AWD system while the engine is running, or while
driving, the warning light will either rema ...
Intelligent key warning buzzer
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “OUTSIDE BUZZER” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Intelligent ...
