Nissan Juke Owners Manual : Headlights

Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer.

Replacing

Halogen headlight model:

The headlight is a semi-sealed beam type which uses a replaceable headlight (halogen) bulb.

CAUTION

• Do not leave the bulb out of the headlight reflector for a long period of time. Dust, moisture, smoke, etc.

entering the headlight body may affect bulb performance.

•  High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.

• Only touch the base when handling the bulb. Never touch the glass envelope. Touching the glass envelope could significantly affect bulb life and/or headlight performance.

•  Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer.

Use the same number and wattage as originally installed as shown in the chart.

Disconnect the battery negative cable before replacing bulbs.


Disconnect the battery negative cable before replacing bulbs.

1. Remove the connector.

2. Turn the holderA and then pull out it.

Remove the cap B and then remove the bulbC .

    Lights
    1. Map light 2. Front side marker light 3. Front fog light (if so equipped) 4. Headlight (high-beam/low-beam) 5. Front turn signal light 6. Front parking light 7. Side turn signal light 8. Da ...

    Exterior and interior lights
    : See a NISSAN dealer for replacement. NOTE: Always check with the Parts Department at a NISSAN dealer for the latest information about parts. : REMOVE : INSTALL Replacement procedures All ...

    Other materials:

    P0089 fuel pump
    DTC Logic DTC DETECTION LOGIC NOTE: • Conditions for applying the diagnostic procedure to the stored DTCs: The DTC becomes present during the first 30 seconds after the engine starts. • In low ambient temperature conditions, diagnostic cannot make difference between a normal long engine st ...

    P0335 CKP sensor (POS)
    DTC Logic DTC DETECTION LOGIC Diagnosis Procedure 1.CHECK GROUND CONNECTIONS 1. Turn ignition switch OFF. 2. Check ground connection E38. Refer to Ground inspection in GI-44, "Circuit Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or ...

    Unexpected brake pedal reaction
    Description A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed. Diagnosis Procedure 1.CHECK FRONT AND REAR AXLE Check that there is no excessive looseness in front and rear axle. • Front axle: Refer to FAX-41, "Inspection". • Rear axle: ...