Nissan Juke Service and Repair Manual : Headlamp washer relay
Component Inspection
1.CHECK HEADLAMP WASHER RELAY
1. Turn the ignition switch OFF.
2. Remove headlamp washer relay.
3. Apply battery voltage to headlamp washer relay between terminals 1 and 2.
4. Check continuity of headlamp washer relay.
Is the inspection result normal? YES >> Headlamp washer relay is normal.
NO >> Replace headlamp washer relay.
Rear wiper auto stop signal circuit
Component Function Check 1.CHECK REAR WIPER (AUTO STOP) OPERATION CONSULT-III DATA MONITOR 1. Select “WIPER” of BCM data monitor item. 2. Operate the rear wiper. 3. Check that “RR WIPER STOP” cha ...Headlamp washer circuit
Component Function Check 1.CHECK HEADLAMP WASHER OPERATION CONSULT-III ACTIVE TEST 1. Select “HEAD LAMP WASHER” of IPDM E/R active test item. 2. With operating the test item, check headlamp operat ...Other materials:
Additional service when replacing ECM
Description
When replacing ECM, this procedure must be performed.
Work Procedure
1.PERFORM INITIALIZATION OF NATS SYSTEM AND REGISTRATION OF ALL NATS
IGNITION KEY IDS
Refer to SEC-50, "BCM : Special Repair Requirement" (With intelligent key
system), SEC-190, "BCM : Work
Proce ...
Lower link
Exploded View
1. Rear suspension member
2. Adjusting bolt
3. Upper link
4. Eccentric disk
5. Lower link
6. Suspension arm bracket
7. Suspension arm
: Vehicle front
: Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Remove tires. Ref ...
Test Value and Test Limit
The following is the information specified in Service $06 of ISO 15031-5.
The test value is a parameter used to determine whether a system/circuit
diagnostic test is OK or NG while
being monitored by the ECM during self-diagnosis. The test limit is a reference
value which is specified as the ...