Nissan Juke Service and Repair Manual : Headlamp washer nozzle and tube
Exploded View
1. Washer tank
2. Headlamp washer tube (tank side)
3. Headlamp washer tube RH
4. Headlamp washer nozzle connector
RH
5. Headlamp washer nozzle bracket RH
6. Headlamp washer nozzle RH
7. Headlamp washer nozzle joint
8. Headlamp washer nozzle bracket LH
9. Headlamp washer nozzle LH
10. Headlamp washer nozzle connector
LH
11. Headlamp washer tube LH 12. Check valve
Hydraulic Layout
1. Headlamp washer nozzle tube
: Clip
Removal and Installation
REMOVAL
1. Remove front bumper fascia. Refer to EXT-13, "Removal and Installation".
2. Disengage headlamp washer tube fixing clip from front bumper.
3. Remove headlamp washer nozzle bracket.
4. Remove headlamp washer nozzle from the front bumper fascia.
INSTALLATION
Install in the reverse order of removal.
Inspection
CHECK VALVE INSPECTION
Check that air can pass through the hose by blowing forward (toward the nozzle), and check that air cannot pass through by sucking.
Washer tank
Exploded View 1. Front washer nozzle LH 2. Front washer nozzle RH 3. Front washer tube LH 4. Front washer tube RH 5. Check valve 6. Front washer tube 7. Joint 8. Washer tank inlet cap ...Other materials:
Air conditioning cut control
Air conditioning cut control : System Diagram
Air conditioning cut control : System Description
INPUT/OUTPUT SIGNAL CHART
*: ECM determines the start signal status by the signals of engine speed and
battery voltage.
SYSTEM DESCRIPTION
This system improves engine operation when the air ...
Component parts
Component Parts Location
1. A/C auto amp.
Refer to HAC-12, "Component Parts
Location".
2. ABS actuator and electric unit (control
unit)
Refer to BRC-9, "Component Parts
Location" (without ESP) or BRC-97,
"Component Parts Location" (with
ESP).
3. ECM
Refer t ...
Transaxle assembly
Exploded View
CASE AND HOUSING
1. Filler plug
2. Gasket
3. Transaxle case
4. Bushing
5. Snap ring
6. Oil channel
7. Oil gutter
8. Position switch
9. Bracket
10. Differential side oil seal
11. Magnet
12. Drain plug
13. Input shaft oil seal
14. Clutch housing
15. 2 way conn ...