Nissan Juke Service and Repair Manual : Headlamp aiming switch
Exploded View
1. Headlamp aiming switch 2. Instrument lower panel assembly LH
: Pawl
Removal and Installation
REMOVAL
1. Remove instrment lower panel (LH/RH). Refer to IP-13, "Removal and Installation".
2. Remove headlamp aiming switch fixing clips, and then remove headlamp aiming switch from instrument lower panel (LH/RH).
INSTALLATION
Install in the reverse order of removal.
Side turn signal lamp
Exploded View 1. Side turn signal lamp bulb 2. Side turn signal lamp hous Removal and Installation CAUTION: Disconnect battery negative terminal or remove the fuse. REMOVAL 1. Remove the sid ...Rear combination lamp
Exploded View REMOVAL 1. Grommet 2. Grommet 3. Rear combination lamp : Clip : N·m (kg-m, in-lb) DISASSEMBLY 1. Rear combination lamp housing assembly 2. Back-up lamp bulb 3. Harness ...Other materials:
Reverse idler shaft and gear
Exploded View
1. Reverse output gear
2. Snap ring
3. Reverse baulk ring
4. Return spring
5. Needle bearing
6. Seal washer
7. Reverse idler shaft
8. Spacer
9. Reverse input gear
10. Lock washer
11. Spring washer
: Replace the parts as a set.
: Always replace after every
disass ...
Auto door lock operation does not operate
Diagnosis Procedure
1.CHECK “AUTO LOCK SET” SETTING IN “WORK SUPPORT”
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode.
3. Check “AUTO LOCK SET” in “WORK SUPPORT”.
Refer to DLK-219, "INTELLIGENT KEY : CONSULT-III Function (BCM - INT ...
Cooling fan
Exploded View
1. Fan motorCooling fan
2. Fan shroud
3. Cooling fan
A. Reverse screw
: Apply thread locking sealant.
: Vehicle front
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
1. Drain engine coolant. Refer to CO-62, "Draining".
2. Disconnect radiator hose (lower) c ...