Nissan Juke Owners Manual : Head restraints/Headrests
WARNING
Head restraint/headrest supplement the other vehicle safety systems. They may provide additional protection against injury in certain rear end collisions.
Adjustable head restraints/headrests must be adjusted properly, as specified in this section. Check the adjustment after someone else uses the seat. Do not attach anything to the head restraint/headrest stalks or remove the head restraint/headrest. Do not use the seat if the head restraint/ headrest has been removed. If the head restraint/headrest was removed, reinstall and properly adjust the head restraint/headrest before an occupant uses the seating position. Failure to follow these instructions can reduce the effectiveness of the head restraint/ headrest. This may increase the risk of serious injury or death in a collision.
The illustration shows the seating positions equipped with head restraint/headrest.
▲ Indicates the seating position is equipped with a head restraint.
■ Indicates the seating position is equipped with a headrest.
+ indicates the seating position is not equipped with a head restraint or headrest.
• Your vehicle is equipped with a head restraint/headrest that may be integrated, adjustable or non-adjustable.
• Adjustable head restraints/headrests have multiple notches along the stalk to lock them in a desired adjustment position.
• The non-adjustable head restraints/headrests have single locking notch to secure them to the seat frame.
• Proper Adjustment:
— For the adjustable type, align the head restraint/headrest so the center of your
ear is approximately level with the center of the head restraint/headrest.
— If your ear position is still higher than the recommended alignment, place the head restraint/headrest at the highest position.
• If the head restraint/headrest has been removed, ensure that it is reinstalled and locked in place before riding in that designated seating position.
- Adjustable head restraint/headrest components
- Non-adjustable head restraint/headrest components
- Remove
- Install
- Adjust
- Front-seat Active Head Restraints
Rear seats
Folding Before folding the rear seats: Secure the seat belts on the seat belt hooks on the side wall. (See “Seat belt hooks” .) To fold the seatback, pull the adjusting knob1 . To return the se ...Adjustable head restraint/headrest components
1. Removable head restraint/headrest 2. Multiple notches 3. Lock knob 4. Stalks ...Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
driver a ...
Front suspension assembly
Inspection
COMPONENT PART
Check the mounting conditions (looseness, backlash) of each component and
component conditions (wear,
damage) are normal.
BALL JOINT AXIAL END PLAY
1. Set front wheels in a straight-ahead position.
2. Measure axial end play by prying it up/down with iron bar or eq ...
B1066, B1071 passenger air bag module
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...