Nissan Juke Service and Repair Manual : Hazard switch
Exploded View
1. Instrument panel assembly 2. Hazard switch
: Pawl
Removal and Installation
REMOVAL
1. Remove Audio unit. Refer to AV-38, "Removal and Installation".
2. Disengage fixing pawls, and then remove hazard switch from instrument panel inside to outside.
INSTALLATION
Install in the reverse order of removal.
Lighting & turn signal switch
Removal and Installation REMOVAL Remove light & turn signal switch. Refer to BCS-94, "Removal and Installation". INSTALLATION Install in the reverse order of removal. ...Side turn signal lamp
Exploded View 1. Side turn signal lamp bulb 2. Side turn signal lamp hous Removal and Installation CAUTION: Disconnect battery negative terminal or remove the fuse. REMOVAL 1. Remove the sid ...Other materials:
Magnet clutch
Component Function Check
1.CHECK MAGNET CLUTCH OPERATION
Perform auto active test of IPDM E/R. Refer to PCS-12, "Diagnosis
Description" (with Intelligent Key) or PCS-
43, "Diagnosis Description" (without Intelligent Key).
Does it operate normally?
YES >> INSPECTION ...
BCM
LHD
LHD : Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...