Nissan Juke Service and Repair Manual : Hazard reminder operation does not operate
Diagnosis Procedure
1.CHECK DTC WITH BCM AND COMBINATION METER
Check that DTC is not detected with BCM and combination meter.
Is the inspection result normal? YES >> GO TO 2.
NO-1 >> Refer to BCS-141, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index". (Combination meter)
2.CHECK “HAZARD LAMP SET” SETTING IN “WORK SUPPORT”
1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.
2. Select “HAZARD LAMP SET” in “WORK SUPPORT” mode.
3. Check “HAZARD LAMP SET” in “WORK SUPPORT”.
Refer to DLK-372, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MULTI REMOTE ENT) (With Super Lock)".
Is the inspection result normal? YES >> GO TO 3.
NO >> Set “HAZARD LAMP SET” in “WORK SUPPORT”.
3.CHECK HAZARD WARNING LAMP
Check hazard warning lamp.
Refer to DLK-400, "Component Function Check".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace the malfunctioning parts.
4.REPLACE BCM
1. Replace BCM. Refer to BCS-161, "Removal and Installation".
2. Confirm the operation after replacement.
Is the result normal? YES >> INSPECTION END
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Key reminder function does not operate
Diagnosis Procedure 1.CHECK DOOR LOCK AND UNLOCK SWITCH Check door lock and unlock switch. Refer to the following. • Driver side: Refer to DLK-391, "DRIVER SIDE : Component Function Check&qu ...Squeak and rattle trouble diagnoses
Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the ...Other materials:
Starting system (with intelligent key)
CVT : Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
M/T : Wiring Diagram
For connector terminal arrangem ...
Back door lock
Exploded View
1. Back door lock assembly
2. TORX bolt
3. Back door striker
: Do not reuse
: N·m (kg-m, ft-lb)
: Body grease
Door lock
DOOR LOCK : Removal and Installation
REMOVAL
1. Remove the back door lower finisher. Refer to INT-35, "BACK DOOR LOWER
FINISHER : Removal and
In ...
TCM branch line circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (unit side and connector
side).
- TCM
- Harness connecotor F1
- Harness ...