Nissan Juke Service and Repair Manual : Hazard function

Component Function Check

1.CHECK FUNCTION

1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.

2. Select “FLASHER” in “ACTIVE TEST” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> Hazard warning lamp circuit is OK.

NO >> Refer to DLK-525, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK HAZARD SWITCH CIRCUIT

Refer to EXL-72, "Component Function Check".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

    Door switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR SW-DR”, “DOOR SW-AS”, “DOOR SW-RL”, “DOOR SW-RR”, “BACK DOOR SW” in “DATA MONITOR” mod ...

    Key switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEY ON SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to ...

    Other materials:

    P0117, P0118 ECT SENSOR
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...

    Headlamp washer circuit
    Component Function Check 1.CHECK HEADLAMP WASHER OPERATION CONSULT-III ACTIVE TEST 1. Select “HEAD LAMP WASHER” of IPDM E/R active test item. 2. With operating the test item, check headlamp operation. On :Headlamp washer ON operation Off :Stop the headlamp washer. Is headlamp washer operation ...

    U0415 vehicle speed
    Description U0415 is displayed if any unusual condition is present in the reception status of the vehicle speed signal from the ABS actuator and electric unit (control unit). DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.DTC CONFIRMATION 1. Erase the DTC. 2. Turn ignition sw ...