Nissan Juke Service and Repair Manual : Hazard function

Component Function Check

1.CHECK FUNCTION

1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III.

2. Select “FLASHER” in “ACTIVE TEST” mode.

3. Check that the function operates normally according to the following conditions.

Is the inspection result normal?


Is the inspection result normal? YES >> Hazard warning lamp circuit is OK.

NO >> Refer to DLK-400, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK HAZARD SWITCH CIRCUIT

Refer to EXL-72, "Component Function Check".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK INTERMITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

>> INSPECTION END

    Door switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “DOOR SW-DR”, “DOOR SW-AS”, “DOOR SW-RL”, “DOOR SW-RR”, “BACK DOOR SW” in “DATA MONITOR” mod ...

    Key switch
    Component Function Check 1.CHECK FUNCTION 1. Select “DOOR LOCK” of “BCM” using CONSULT-III. 2. Select “KEY ON SW” in “DATA MONITOR” mode. 3. Check that the function operates normally according to ...

    Other materials:

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

    High-mounted stop lamp
    Exploded View 1. High-mounted stop lamp 2. Seal packing : N·m (kg-m, in-lb) Removal and Installation CAUTION: Disconnect battery negative terminal or remove the fuse. REMOVAL 1. Remove blind seal from back door inside. CAUTION: Be careful not to damage the blind seal, so that it can b ...

    ABS warning lamp
    Component Function Check 1.CHECK ABS WARNING LAMP FUNCTION Check that ABS warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CAUTION: Never start engine. Is the inspection result normal? YES >> INSPECTION END NO >> Proceed to B ...