Nissan Juke Service and Repair Manual : Handling precaution

Nissan Dynamic Control System

• The engine torque, engine power, boost, and instantaneous fuel consumption are provided for information purposes only. They are not intended to prompt the driver to adjust driving style. The readings may be slightly delayed relative to the actual vehicle behaviors. This is not a malfunction.

• The voltmeter reading cannot be used as an indicator for battery replacement because it indicates the input voltage to the multi display unit, not the battery voltage.

• The SET UP screen are viewable and operable only while the vehicle is stopped.

• The ECO information screen is operable only while the vehicle is stopped.

• If no time setting is performed, the daily and weekly fuel consumption history data are not displayed.

• The readings may differ from the actual values depending on driving conditions.

    System
    NISSAN dynamic control system NISSAN DYNAMIC CONTROL SYSTEM : System Description SYSTEM DIAGRAM • *1: M/T models except for K9K engine models • *2: CVT models MULTI DISPLAY UNIT INPUT/OUTPUT SI ...

    Diagnosis system (multi display unit)
    CONSULT-III Function APPLICATION ITEM CONSULT-III performs the following functions via CAN communication with multi display unit. SELF DIAGNOSTIC RESULT Refer to AV-111, "DTC Index". ...

    Other materials:

    Wiring diagram
    HORN Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    P159B G sensor
    For M/T models : DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test. 1. Turn ignition switch OFF and wait at least 10 seconds. 2. T ...

    B2099 ignition relay off stuck
    Description The ignition relay integrated in IPDM E/R is operated with ignition switch ON signal from the ignition switch. DTC Logic DTC DETECTION LOGIC NOTE: When IPDM E/R power supply voltage is low (Approx. 7 - 8 V for about 1 second), the “DTC: B2099” may be detected. 1.PERFORM DTC ...