Nissan Juke Service and Repair Manual : GPS antenna
Feeder Layout
Removal and Installation
REMOVAL
1. Remove instrument panel. Refer to IP-12, "Exploded View".
2. Remove antenna feeder clip, then remove GPS antenna screw and remove GPS antenna.
INSTALLATION
Install in the reverse order of removal.
Antenna base
Exploded View 1. Antenna rod 2. Antenna base : N·m (kg-m, in-lb) Removal and Installation REMOVAL 1. Remove headlining. Refer to INT-26, "Exploded View". 2. Disconnect antenna feed ...Microphone
Removal and Installation REMOVAL 1. Remove headlining. Refer to INT-26, "Exploded View". 2. Remove microphone connector and pawl to remove microphone. INSTALLATION Install in the reve ...Other materials:
Wheel Alignment
HR16DE, K9K
Measure value under unladen*2 conditions.
*1: Since adjustment mechanism is not included, the value of the left and right
wheels (both wheels) must be
used as the standard value.
*2: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools
and mats are in des ...
P0848 transmission fluid pressure SEN/SW B
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, the ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
With ...
P1212 TCS communication line
Description
This CAN communication line is used to control the smooth engine operation
during the TCS operation. Pulse
signals are exchanged between ECM and “ABS actuator and electric unit (control
unit)”.
Be sure to erase the malfunction information such as DTC not only for “ABS
actuator ...