Nissan Juke Service and Repair Manual : Glow plug

Exploded View

1. Glow plug


1. Glow plug

: N·m (kg-m, ft-lb) Engine front
Removal and Installation: N·m (kg-m, ft-lb)


Removal and Installation

REMOVAL

CAUTION:
Remove glow plug only if necessary. If carbon adheres, it may be stuck and broken.

1. Disconnect the battery cable from the negative terminal.

2. Remove cowl top extension. Refer to EXT-20, "Exploded View".

3. Remove engine under cover.

4. Remove turbocharger air inlet pipe. Refer to EM-280, "Exploded View".

5. Remove air inlet tube assembly and air inlet tube. Refer to EM-281, "Exploded View".

6. Remove High pressure protection cover (upper). Refer to EM-294, "Exploded View".

7. Disconnect harness connector from glow plug.

8. Remove glow plug.

CAUTION:
• When removing or installing, never use such tools as an air impact wrench.

• Handle it carefully without giving any impact, even after removal. [As a guide, if it drops from height of 10 cm (3.94 in) or higher, always replace it.]

INSTALLATION

1. Remove adhered carbon from glow plug installation hole with a reamer.

2. Install glow plug.

3. Install remaining parts in reverse order of removal.

    Oil pan
    Exploded View 1. Baffle plate 2. Gasket 3. Oil pan 4. O-ring 5. Drain plug 6. Oil level gauge guide 7. Transaxle 8. Crankshaft position sensor (POS) : N·m (kg-m, ft-lb) : N·m (kg-m, i ...

    Vacuum pump
    Exploded View 1. Vacuum pump 2. Gasket 3. Damper valve bracket 4. Vacuum hose A. To electric throttle control actuator Engine front : N·m (kg-m, ft-lb) : Always replace after every disa ...

    Other materials:

    Auto door lock operation does not operate
    Diagnosis Procedure 1.CHECK “AUTO LOCK SET” SETTING WITH CONSULT-III 1. Select “MULTI REMOTE ENT” of “BCM” using CONSULT-III. 2. Select “AUTO LOCK SET” in “WORK SUPPORT” mode. 3. Check “AUTO LOCK SET” in “WORK SUPPORT”. Refer to DLK-502, "MULTI REMOTE ENT : CONSULT-III Function (BCM - MU ...

    P1614 chain of IMMU-KEY
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1 1. Contact Intelligent Key backside to push-button ignition switch. 2. Check DTC in “Self Diagnostic Result” mode of “ENGINE” using CONSULT-III. Is DTC detected? YES >> Go to SEC-55, &quo ...

    Radiator : Inspection
    Check radiator for mud or clogging. If necessary, clean radiator as follows. CAUTION: • Be careful not to bend or damage radiator fins. • When radiator is cleaned without removal, remove all surrounding parts such as radiator cooling fan assembly and horns. Then tape harness and harness conn ...