Nissan Juke Service and Repair Manual : General Precautions

WARNING:
When replacing fuel line parts, be sure to observe the following.

• Put a ???CAUTION: FLAMMABLE??? sign in the workshop.

• Be sure to work in a well ventilated area and furnish workshop with a CO2 fire extinguisher.

• Never smoke while servicing fuel system. Keep open flames and sparks away from the work area.

CAUTION:
• Use gasoline required by the regulations for octane number. Refer to GI-35, "Fuel".

• Before removing fuel line parts, perform out the following procedures: - Put drained fuel in an explosion-proof container and put the lid on securely. Keep the container in safe area.

- Release fuel pressure from the fuel lines. Refer to EC-551, "Work Procedure".

- Disconnect the battery cable from the negative terminal.

• Always replace O-ring and clamps with new ones.

• Never kink or twist tubes when they are being installed.

• Never tighten hose clamps excessively to avoid damaging hoses.

• After installing tubes, check there is no fuel leakage at connections in the following steps.

- Apply fuel pressure to fuel lines with turning ignition switch ???ON??? (with engine stopped). Then check for fuel leakage at connections.

- Start engine and rev it up and check for fuel leakage at connections.

• Use only a genuine NISSAN fuel filler cap as a replacement. If an incorrect fuel filler cap is used, the ???MI??? may come on.

• For servicing ???EVAPORATIVE EMISSION SYSTEM??? parts, refer to EC-480, "EVAPORATIVE EMISSION SYSTEM : System Diagram".

    Other materials:

    Exploded View
    M/T models 1. Clamp 2. Water hose 3. Oil cooler 4. Water hose N·m (kg-m, in-lb) CVT models 1. Clamp 2. Water hose 3. Oil cooler 4. Water hose 5. Water hose 6. Heater thermostat 7. Water hose A. To CVT oil warmer : N·m (kg-m, in-lb) ...

    Diagnosis system (BCM) (without intelligent key system)
    Description Air conditioning system performs self-diagnosis, operation check, function diagnosis, and various settings using diagnosis function of each control unit. Common item : consult-III Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT-III performs the following functions via CAN ...

    P0112, P0113 IAT SENSOR
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.PERFORM DTC CONFIRMATION PROCEDURE ...