Nissan Juke Service and Repair Manual : G sensor calibration

Description

ECM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed.

• Removal/installation or replacement of G sensor • Replacement of ECM

Work Procedure

1.PREPARATION BEFORE CALIBRATION PROCEDURE

1. Park the vehicle on a level surface.

2. Adjust air pressure of all tires to the specified pressure. WT-9, "Tire Air Pressure".

>> GO TO 2.

2.PERFORM CALIBRATION

1. Turn ignition switch ON. With CONSULT-III


1. Turn ignition switch ON.

CAUTION:
Never start engine.

2. Select “Work Support” mode in “ENGINE.

3. Select “G SENSOR CALIBRATION”.

4. Touch “Start”.

CAUTION:


Never swing the vehicle during “G sensor calibration

”.

Is “COMPLETED” displayed? YES >> END NO >> Perform steps 1 and 2 again.

    Idle air volume learning
    Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following ...

    Mixture ratio self-learning value clear
    Description This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”. Work Procedure With CONSULT-III 1. Sta ...

    Other materials:

    Stall test
    Inspection and Judgment INSPECTION 1. Inspect the amount of engine oil. Replenish the engine oil if necessary. 2. Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the amount of CVT fluid. Replenish if necessary. 3. Secu ...

    Rear window defogger system
    Wiring Diagram - DEFOGGER CONTROL SYSTEM - For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...

    Operation inspection
    Work Procedure The purpose of the operational check is to check that the individual system operates normally. Check condition : Engine running at normal operating temperature. 1.CHECK BLOWER MOTOR 1. Operate fan control dial. 2. Check that fan speed changes. Check operation for all fan speeds ...