Nissan Juke Service and Repair Manual : G sensor calibration

Description

TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed.

• Removal/installation or replacement of G sensor • Replacement of TCM

Procedure

1.PREPARATION BEFORE CALIBRATION PROCEDURE

1. Park the vehicle on a level surface.

2. Adjust air pressure of all tires to the specified pressure. WT-9, "Tire Air Pressure".

>> GO TO 2.

2.PERFORM CALIBRATION

1. Turn ignition switch ON.With CONSULT-III


1. Turn ignition switch ON.

CAUTION:
Never start engine.

2. Select “Work Support” in “TRANSMISSION”.

3. Select “G SENSOR CALIBRATION”.

4. Touch “Start”.

CAUTION:
Never swing the vehicle during “G sensor calibration”.

Is “COMPLETED” displayed? YES >> GO TO 3.

NO >> Perform steps 1 and 2 again.

3.PERFORM THE SELF-DIAGNOSIS

1. Turn ignition switch OFF and wait for 10 seconds.With CONSULT-III


1. Turn ignition switch OFF and wait for 10 seconds.

2. Turn ignition switch ON.

3. Select “Self Diagnostic Results” in “TRANSMISSION”.

Is “P1586” or “P1588” detected? YES >> Go to TM-366, "DTC Index".

NO >> Calibration end

    Additional service when replacing transaxle assembly
    Description Perform the following work after the transaxle assembly is replaced. Erasing the calibration data • The TCM acquires calibration data (individual characteristic value) of each solen ...

    CVT fluid
    Replacement CVT fluid : Refer to TM-512, "General Specification". Fluid capacity : Refer to TM-512, "General Specificatio CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Using tr ...

    Other materials:

    Tire dressing
    NISSAN does not recommend the use of tire dressings. Tire manufacturers apply a coating to the tires to help reduce discoloration of the rubber. If a tire dressing is applied to the tires, it may react with the coating and form a compound. This compound may come off the tire while driving and s ...

    Manual Transmission (MT)
    The ignition switch includes a device that helps prevent accidental removal of the key while driving. The key can only be removed when the ignition switch is in the LOCK position. To turn the ignition switch to the LOCK position from the ACC or ON position, turn the key to the OFF position, ...

    Clutch fluid
    RS5F92R : Inspection FLUID LEAKAGE • Check clutch line for cracks, deterioration or other damage. Replace any damaged parts. • Check for fluid leakage by fully depressing clutch pedal while engine is running. CAUTION: If leakage occurs around joints, reinstall the joints or, if necessary, ...