Nissan Juke Service and Repair Manual : G sensor

Exploded View

1. G sensor


1. G sensor

: N·m (kg-m, in-lb): Vehicle front
Removal and Installation: N·m (kg-m, in-lb)


Removal and Installation

CAUTION:
• Never drop or strike G sensor, because it has little tolerance for impact.

• Never use a power tool to avoid impact.

REMOVAL

1. Disconnect the battery cable from the negative terminal. Refer to PG-124, "Removal and Installation".

2. Remove driver seat (LHD) or passenger seat (RHD). Refer to SE-19, "Removal and Installation".

3. Remove center pillar lower garnish (left side) and dash side finisher (left side). Refer to INT-20, "CENTER PILLAR LOWER GARNISH : Removal and Installation" (center pillar lower garnish) and INT-20, "DASH SIDE FINISHER : Removal and Installation" (dash side finisher).

4. Pull up floor carpet. Refer to INT-23, "Removal and Installation".

5. Disconnect G sensor harness connector.

6. Remove G sensor.

7. Remove bracket.

INSTALLATION

Installation is the reverse order of removal.

Adjustment

ADJUSTMENT AFTER INSTALLATION

Perform “G SENSOR CALIBRATION”. Refer to TM-377, "Description".

    Air breather hose
    Removal and Installation REMOVAL 1. Remove air cleaner case. Refer to EM-26, "Removal and Installation". 2. Remove clip from bracket. 3. Remove air breather hose from transaxle assembly. ...

    Control valve
    Exploded View COMPONENT PARTS LOCATION 1. Transaxle assembly 2. Control valve 3. Bracket 4. O-ring 5. Oil strainer assembly 6. Magnet 7. Drain plug gasket 8. Drain plug 9. Oil pan mo ...

    Other materials:

    Clutch fluid
    RS5F92R : Inspection FLUID LEAKAGE • Check clutch line for cracks, deterioration or other damage. Replace any damaged parts. • Check for fluid leakage by fully depressing clutch pedal while engine is running. CAUTION: If leakage occurs around joints, reinstall the joints or, if necessary, ...

    Impossible to shut off engine
    Description CHART 4: IMPOSSIBLE TO SHUT OFF ENGINE Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or re ...

    Location of plastic parts
    Precautions for Plastics CAUTION: • When repairing and painting a portion of the body adjacent to plastic parts, consider their characteristics (influence of heat and solvent) and remove them if necessary or take suitable measures to protect them. • Plastic parts should be repaired and pai ...