Nissan Juke Service and Repair Manual : Fusible link inspection
How To Check
A melted fusible link can be detected either by visual inspection or by feeling with finger tip. If its condition is questionable, use circuit tester or test lamp.
1 :Fusible link
CAUTION:
• If fusible link should melt, it is possible that critical circuit
(power supply or large current carrying circuit) is shorted. In
such a case, carefully check and eliminate cause of malfunction.
• Never wrap outside of fusible link with vinyl tape. Important: Never let fusible link touch any other wiring harness, vinyl or rubber parts.
Fuse inspection
How To Check • If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse. • Use fuse of specified rating. Never use fuse of more than specified rating. • Do not parti ...Battery charging chart
Slow Charge 1.DETERMINE INITIAL CHARGING CURRENT 1. Determine initial charging current from specific gravity. 2. Check battery type and determine the specified current using the table. NOTE: Af ...Other materials:
Side air bag module
Exploded View
1. Side air bag module
2. Front seat assembly
: Do not reuse
: N·m (kg-m, in-lb)
Removal and Installation
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative
terminal and wait 3 minutes
or more.
• Always work from the side of air bag module. ...
Seats
WARNING
• Do not ride in a moving vehicle when the seatback is reclined. This can
be dangerous. The shoulder belt will not be against your body. In an accident, you
could be thrown into it and receive neck or other serious injuries. You could also
slide under the lap belt and receive seriou ...
Rear regulator
Exploded View
1. Rear door panel
2. Sealing screen
3. Lower sash (front)
4. Rear door regulator assembly
5. Power window motor
6. Rear door glass
7. Lower sash (rear)
8. Rear door glass run
Removal and Installation
REMOVAL
1. Remove rear door glass. Refer to GW-21, "Removal an ...