Nissan Juke Service and Repair Manual : Fuel pump control modul (FPCM)
Removal and Installation
REMOVAL
1. Remove Luggage side lower finisher LH. Refer to INT-31, "LUGGAGE SIDE LOWER FINISHER : Removal and Installation".
2. Disconnect fuel pump control module (FPCM) connector.
3. Remove mounting bolts and then remove fuel pump control module (FPCM).
INSTALLATION
Install in the reverse order of removal.
ECM
Removal and Installation REMOVAL 1. Remove fusible link bracket. Keep a service area. 2. Disconnect ECM harness connectors. Refer to PG-4, "Harness Connector". 3. Remove ECM mounting nut ...Service data and specifications (SDS)
Idle Speed *: Under the following conditions • A/C switch: OFF • Electric load: OFF (Lights, heater fan & rear window defogger) • Steering wheel: Kept in straight-ahead position Ignition Ti ...Other materials:
LAN System can system (type 11)
DTC/CIRCUIT DIAGNOSIS
Main line between IPDM-E and DLC circuit
Diagnosis Procedure
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose
connection (connector s ...
Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
NOTE:
• Before removing and installing any control units, first turn the ignition
switch to the LOCK position, then disconnect
both battery cables.
• After finishing work, confirm that all control unit connectors are connected
properly, then re-connect both
battery cables.
• Always use CONS ...
Key ID warning does not operate
Diagnosis Procedure
1.CHECK DTC WITH BCM AND COMBINATION METER
Check that DTC is not detected with BCM and combination meter.
Is the inspection result normal?
YES >> GO TO 2.
NO-1 >> Refer to BCS-67, "DTC Index". (BCM)
NO-2 >> Refer to MWI-36, "DTC Index&qu ...