Nissan Juke Service and Repair Manual : Front wiper motor ground circuit
Diagnosis Procedure
1.CHECK FRONT WIPER MOTOR GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect front wiper motor connector.
3. Check continuity between front wiper motor harness connector and ground.
Is the inspection result normal? YES >> INSPECTION END
NO >> Repair or replace harness.
Front wiper auto stop signal circuit
Component Function Check 1.CHECK FRONT WIPER (AUTO STOP) SIGNAL CONSULT-III DATA MONITOR 1. Select “WIP AUTO STOP” of IPDM E/R data monitor item. 2. Operate the front wiper. 3. With the front wip ...Light & rain sensor
Component Function Check 1.CHECK FRONT WIPER AUTO OPERATION 1. Clean rain sensor detection area of windshield fully. 2. When the front wiper switch is turned to AUTO position, front wiper operates ...Other materials:
Inspection
LEVEL
• Check that the reservoir tank engine coolant level is within the
“MIN” to “MAX” when the engine is cool.
A : MAX
B : MIN
• Adjust the engine coolant level if necessary.
LEAKAGE
• To check for leakage, apply pressure to the cooling system with the
radiator cap tester (commercial ser ...
Steering switch signal B circuit
Description
Transmits the steering switch signal to NAVI control unit.
Diagnosis Procedure
1.CHECK STEERING SWITCH SIGNAL B CIRCUIT
1. Disconnect NAVI control unit connector and spiral cable connector.
2. Check continuity between NAVI control unit harness connector and spiral cable
harness co ...
Hazard function
Component Function Check
1.CHECK FUNCTION
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “FLASHER” in “ACTIVE TEST” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Hazard warning lamp ...