Nissan Juke Service and Repair Manual : Front wheel hub and knuckle
Inspection
COMPONENT PART
Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)
Check the following items, and replace the part if necessary.
• Move wheel hub assembly in the axial direction by hand. Check there is no looseness of wheel bearing.
Axial end play : Refer to FAX-90, "Wheel Bearing".
• Rotate wheel hub assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub assembly.
Front drive shaft
Inspection Check the following items, and replace the part if necessary. • Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft assemb ...Other materials:
Wheel Alignment
2WD
Measure value under unladen*2 conditions.
*1: A difference when assuming the left side a standard.
*2: Fuel, engine coolant and lubricant are full. Spare tire, jack, hand tools
and mats are in designated positions.
4WD
Measure value under unladen*2 conditions.
*1: A differenc ...
B27A0, B27A1 intake door motor
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC is displayed along with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to HAC-
51, "DTC Logic".
• If DTC is displayed along with DTC U1010, first perform the trouble diagnosis
for DTC U1010. HAC-52,
"DTC Logic ...
Turbocharger (If Equipped)
The turbocharger turbine revolves at extremely high speeds and
becomes very hot. Therefore, it is essential to maintain a clean supply
of oil flowing through the turbocharger and to follow all required
maintenance instructions and operating procedures.
• Always use the recommended oil. Follow ...