Nissan Juke Service and Repair Manual : Front wheel hub and knuckle
Inspection
COMPONENT PART
Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)
Check the following items, and replace the part if necessary.
• Move wheel hub assembly in the axial direction by hand. Check there is no looseness of wheel bearing.
Axial end play : Refer to FAX-60, "Wheel Bearing".
• Rotate wheel hub assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub assembly.
Front drive shaft
Inspection Check the following items, and replace the part if necessary. • Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft assemb ...Other materials:
P1652 starter motor system COMM
Description
ECM controls ON/OFF state of the starter relay, according to the engine and
vehicle condition. Models with no
Intelligent Key System transmit a control signal directly to IPDM E/R. On the
other hand, models with the Intelligent
Key System transmit a control signal to IPDM E/R by w ...
Steering column
Exploded View
1. Cover
2. Sub-harness
3. Band
4. Steering column assembly
5. Slide plate (inner)
6. Slide plate (outer)
7. Bracket
Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
Removal and Installation
REMOVAL
CAUTION:
• While removing the ste ...
Steering does not lock
Description
Steering does not lock when door is open while ignition switch is OFF.
NOTE:
Before performing the diagnosis, check “Work Flow”. Refer to SEC-47, "Work
Flow".
Diagnosis Procedure
1.CHECK DOOR SWITCH
Check door switch.
Refer to DLK-87, "Component Function Check ...