Nissan Juke Service and Repair Manual : Front wheel hub and knuckle
Inspection
COMPONENT PART
Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal.
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE)
Check the following items, and replace the part if necessary.
• Move wheel hub assembly in the axial direction by hand. Check there is no looseness of wheel bearing.
Axial end play : Refer to FAX-35, "Wheel Bearing".
• Rotate wheel hub assembly and check there is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub assembly.
Front drive shaft
Inspection Check the following items, and replace the part if necessary. • Check drive shaft mounting point and joint for looseness and other damage. CAUTION: Replace entire drive shaft assemb ...Other materials:
Component parts
Component Parts Location
1. Intelligent Key warning buzzer
2. Remote keyless entry receiver
3. Inside key antenna (instrument center)
4. TCM
Refer to TM-133, "CVT CONTROL
SYSTEM : TCM" (RE0F10B models)
or TM-316, "CVT CONTROL SYSTEM
: TCM" (RE0F11A models)
5. Push-bu ...
Throttle valve closed position learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the
fully closed position of the throttle
valve by monitoring the throttle position sensor output signal. It must be
performed each time harness connector
of electric throttle control actuator or ECM is disconne ...
Engine coolant temperature gauge
The gauge 1 indicates the engine coolant temperature.
The engine coolant temperature is within the normal range when the gauge is within
the zone 2 shown in the illustration.
The engine coolant temperature varies with the outside air temperature and driving
conditions.
CAUTION
If the gauge i ...