Nissan Juke Service and Repair Manual : Front power window switch (passenger side)
Component Function Check
1. CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) FUNCTION
Check front power window motor (passenger side) operation with front power window switch (passenger side).
Is the inspection result normal? YES >> INSPECTION END
NO >> Refer to PWC-22, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect front power window switch (passenger side) connector.
3. Turn ignition switch ON.
4. Check voltage between front power window switch (passenger side) harness connector and ground.
(): RHD models
Is the inspection result normal? YES >> GO TO 3.
NO >> GO TO 2.
2.CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE) CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect power window main switch connector.
3. Check continuity between front power window switch (passenger side) harness connector and power window main switch harness connector.
4. Check continuity between front power window switch (passenger side) harness connector and ground.
(): RHD models
Is the inspection result normal? YES >> Replace power window main switch.
NO >> Repair or replace harness.
3.CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE)
Check front power window switch (passenger side).
Refer to PWC-23, "Component Inspection".
Is the inspection result normal? YES >> GO TO 4.
NO >> Replace front power window switch (passenger side).
4.CHECK INTERMITTENT INCIDENT
Refer to GI-42, "Intermittent Incident".
>> INSPECTION END
Component Inspection
1.CHECK FRONT POWER WINDOW SWITCH (PASSENGER SIDE)
1. Turn ignition OFF.
2. Disconnect front power window switch (passenger side) connector.
3. Check front power window switch (passenger side) terminals under the following conditions.
[LHD models]
[RHD models]
Is the inspection result normal? YES >> INSPECTION END
NO >> Replace front power window switch (passenger side).
Power supply and ground circuit
Power window main switch POWER WINDOW MAIN SWITCH : Diagnosis Procedure 1.CHECK POWER WINDOW MAIN SWITCH POWER SUPPLY 1. Turn ignition OFF. 2. Disconnect power window main switch connector. 3. Ch ...Rear power window switch
Component Function Check 1. CHECK REAR POWER WINDOW SWITCH FUNCTION Check rear power window motor operation with rear power window switch. Is the inspection result normal? YES >> INSPECTIO ...Other materials:
P0327, P0328 KS
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform
the following procedure
before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition swit ...
B2621 inside antenna
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Select “INTELLIGENT KEY” of “BCM” using CONSULT-III.
2. Select “INSIDE ANT DIAGNOSIS” in “WORK SUPPORT” mode.
3. Perform inside key antenna (“INSIDE ANT DIAGNOSIS”) on “WORK SUPPORT” of
“INTELL ...
Diagnosis system (BCM) (without intelligent key system)
Common item : consult-III Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for ...