Nissan Juke Service and Repair Manual : Front oil seal

FRONT OIL SEAL : Removal and Installation

REMOVAL

1. Remove the following parts.

• Front fender protector (RH): Refer to EXT-22, "Exploded View".

• Drive belt: Refer to EM-20, "Exploded View".

• Crankshaft pulley: Refer to EM-67, "Exploded View".

2. Remove front oil seal with a suitable tool.

CAUTION:
Be careful not to damage front cover and crankshaft.

INSTALLATION

1. Apply new engine oil to new front oil seal joint surface and seal lip.

2. Install front oil seal so that each seal lip is oriented as shown in the figure.

A : Dust seal lip
B : Oil seal lip
: Engine inside: Engine outside
: Engine inside


• Press-fit front oil seal using a suitable drift with outer diameter 57 mm


• Press-fit front oil seal using a suitable drift with outer diameter 57 mm (2.24 in) and inner diameter 45 mm (1.77 in).

Within 0.3 mm (0.012 in) toward engine front (crankshaft pulley side) Within 0.5 mm (0.020 in) toward engine rear (crankshaft sprocket side)

CAUTION:
• Be careful not to damage front cover and crankshaft.

• Press-fit oil seal straight to avoid causing burrs or tilting.

3. Install in the reverse order of removal, for the rest of parts.

    Valve oil seal
    VALVE OIL SEAL : Removal and Installation REMOVAL 1. Remove camshafts. Refer to EM-78, "Exploded View". 2. Remove valve lifters. Refer to EM-78, "Exploded View". 3. Rotate cran ...

    Rear oil seal
    REAR OIL SEAL : Removal and Installation REMOVAL 1. Remove transaxle assembly. Refer to TM-301, "Exploded View" (CVT models) or TM-84, "MR16DDT : Exploded View" (M/T models). ...

    Other materials:

    Thermo plunger unit
    Exploded View 1. Side member LH 2. Thermo plunger control unit 3. Thermo plunger relay 4. Thermo plunger connector 5. Earth lead 6. Thermo plunger unit 7. Bracket stay Vehicle front : N·m (kg-m, in-lb) Removal and Installation REMOVAL 1. Remove battery cable from the negative ter ...

    Adjustment of steering angle sensor neutral position
    Description Always adjust the neutral position of steering angle sensor before driving when the following operation is performed. Work Procedure ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR CAUTION: Always use CONSULT-III when adjusting the neutral position of steering angle senso ...

    NISSAN Vehicle Immobilizer System
    The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of the registered key. If the engine fails to start using the registered key, it may be due to interference caused by another registered key, an automated toll road device or automated payment device on t ...