Nissan Juke Service and Repair Manual : Front grille
Exploded View
1. Bumper fascia assembly
2. Front side grille RH
3. Front center grille
4. Emblem
5. Front side grille LH
: Pawl
Removal and Installation
REMOVAL
CAUTION:
When remove front grilles (1) apply protective tape (A) on the
bumper fascia (2) to protect the painted surface from damage.
1. Fully open hood assembly.
2. Remove front center grille upper fixing clips (A).
CAUTION:
Apply protective tape (B) around bumper fascia
.
3. Disengage fixing pawls from back side while pulling front center grille to wade vehicle front, and then remove front center grille.
: Pawl
4. Remove front side grille (LH and RH) upper fixing clips (A).
5. Disengage fixing pawls from back side of front side grille (LH and RH).
: Pawl
CAUTION:
Apply protective tape (B) around bumper fascia.
6. Remove front side grille (LH and RH) to ward vehicle front.
7. Remove emblem after removing front grille.
INSTALLATION
Install in the reverse order of removal.
Rear bumper
Exploded View 1. Bumper side bracket LH 2. Bumper closing LH 3. Bumper fascia assembly 4. Reflex reflector LH 5. Rear panel lower 6. U nut 7. Bumper fascia lower 8. Reflex reflector RH ...Cowl top
Exploded View LHD models 1. Front fender cover RH 2. Cowl top cover seal 3. Blind plug RH 4. Cowl top cover 5. Cowl top cover cap 6. Cowl top extension 7. EPT seal [t: 3.0 mm (0.118 in)] ...Other materials:
Vehicle load capacity
Do not exceed the load limit of your vehicle shown as “The combined weight of
occupants and cargo” on the Tire and Loading Information label. Do not exceed the
number of occupants shown as “Seating Capacity” on the Tire and Loading Information
label.
To get “the combined weight of occupants a ...
Head restraints/Headrests
WARNING
Head restraint/headrest supplement the other vehicle safety systems. They
may provide additional protection against injury in certain rear end collisions.
Adjustable head restraints/headrests must be adjusted properly, as specified
in this section. Check the adjustment after someone el ...
Reservoir tank cap
Inspection
• Check valve seat of reservoir tank cap.
- Check if valve seat (A) is swollen to the extent that the edge of the
metal plunger (B) cannot be seen when watching it vertically from
the top.
- Check if valve seat has no soil and damage.
• Pull negative-pressure valve to open it, a ...