Nissan Juke Service and Repair Manual : Front fender

Exploded View

1. Front fender assembly


1. Front fender assembly 2. Front fender stiffener

Removal and Installation: Vehicle fr


Removal and Installation

REMOVAL

1. Remove front fillet molding. Refer to EXT-26, "FRONT FILLET MOLDING : Removal and Installation".

2. Remove front bumper fascia assembly. Refer to EXT-13, "Removal and Installation".

3. Remove sill cover. Refer to EXT-23, "Removal and Installation".

4. Remove fender protector. Refer to EXT-22, "Removal and Installation".

5. Remove front fender cover. Refer to EXT-20, "Exploded View".

6. Remove front combination lamp. Refer to EXL-91, "Removal and Installation".

7. Remove side turn signal lamp. Refer to EXL-98, "Removal and Installation".

8. Remove mounting bolts of front fender assembly.

9. Remove front fender stiffener (2) from the vehicle body while carefully pulling upper portion of front fender (1) toward vehicle outside.

: Vehicle front


10. Remove front fender assembly.


10. Remove front fender assembly.

CAUTION

:
An viscous urethane foam is installed on the back surface of front fender. When removing the front fender, be careful to not deform the front fender while performing the procedure and removing the viscous urethane foam a little at a time.

INSTALLATION

Note the following items, and install in the reverse order of removal.

CAUTION:
• After installation, apply the touch-up paint (the body color) onto the head of front fender mounting bolts.

• After installation, adjust the following part.

- Hood assembly: Refer to DLK-305, "HOOD ASSEMBLY : Adjustment".

- Front door: Refer to DLK-319, "DOOR ASSEMBLY : Adjustment".

    Radiator core support
    HR16DE HR16DE : Exploded View 1. Radiator core support upper 2. Air guide RH (MT models) 3. Radiator core support lower 4. Air guide LH 5. Air guide (upper) 6. Air guide LH (CVT models) 7. ...

    Front door
    Exploded View 1. Front door panel 2. Grommet 3. TORX bolt 4. Door striker 5. Door pad 6. Bumper rubber 7. Door check link 8. Door hinge (lower) 9. Door hinge (upper) 10. Grommet : D ...

    Other materials:

    Installing front license plate
    Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag. •  License plate bracket •  J-nut  2 •  Screw  2 • Screw grommet  2 1. Park the vehicle on flat, level g ...

    Vehicle information
    Identification information Japan production models JAPAN PRODUCTION MODELS : Model Variation Model variation code (Prefix and suffix designations) JAPAN PRODUCTION MODELS : Information About Identification or Model Code IDENTIFICATION NUMBER 1. Air conditioner specification label 2. Ve ...

    Front washer nozzle and tube
    Exploded View LHD models 1. Front washer nozzle LH 2. Front washer nozzle RH 3. Cowl top cover 4. Front washer tube (tank side) 5. Front washer tube RH 6. Front washer tube LH : Vehicle front Hydraulic Layout 1. Front washer nozzle 2. Check valve 3. Front washer 4. Washer tank ...