Nissan Juke Service and Repair Manual : Front drive shaft
Inspection
Check the following items, and replace the part if necessary.
• Check drive shaft mounting point and joint for looseness and other damage.
CAUTION:
Replace entire drive shaft assembly when noise or vibration occurs from drive
shaft
.
• Check boot for cracks and other damage.
Front wheel hub and knuckle
Inspection COMPONENT PART Check that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. WHEEL HUB ASSEMBLY (BEARING-INTEGRATED ...Other materials:
B2632, B2633 air mix door motor PBR
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT-III
1. Turn ignition switch ON.
2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.
3. Check DTC.
Is DTC detected?
YES >> Refer to HAC-155, "Diagnosis P ...
Parking brake shoe
Adjustment
1. Adjust parking brake lever stroke. Refer to PB-2, "Inspection and
Adjustment".
2. Perform parking brake break-in (drag on) operation by driving vehicle under
the following conditions:
• Drive forward
• Vehicle speed: Approx. 43 km/h (27 MPH) set (constant and forward) ...
To protect your vehicle from corrosion
• Wash and wax your vehicle often to keep the vehicle clean.• • Always check
for minor damage to the paint and repair it as soon as possible.• • Keep drain
holes at the bottom of the doors open to avoid water accumulation.• • Check the
underbody for accumulation of sand, dirt or salt. If ...