Nissan Juke Service and Repair Manual : Front door speaker
Removal and Installation
REMOVAL
1. Remove front door finisher. Refer to INT-13, "Exploded View".
2. Remove front door speaker screws, then disconnect front door speaker connector and remove front door speaker.
INSTALLATION
Install in the reverse order of removal.
Navi control unit
Removal and Installation REMOVAL 1. Remove cluster lid C. Refer to IP-12, "Exploded View". 2. Remove NAVI control unit screws. 3. Disconnect NAVI control unit connectors to remove NAVI c ...Tweeter
Removal and Installation REMOVAL 1. Remove front pillar garnish. Refer to INT-18, "Exploded View". 2. Remove tweeter clip, then disconnect tweeter connector and remove tweeter. INSTALL ...Other materials:
P0300, P0301, P0302, P0303, P0304 misfire
DTC Logic
DTC DETECTION LOGIC
When a misfire occurs, engine speed will fluctuate. If the engine speed
fluctuates enough to cause the crankshaft
position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is
occurring.
The misfire detection logic consists of the following t ...
B1138, B1139, B1140, B1141, B1142, B1143 diagnosis sensor unit
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
B1086 seat belt Pre-tensioner LH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...