Nissan Juke Service and Repair Manual : For frontal collision : When SRS is activated in a collision

Nissan Juke Service and Repair Manual / SRS Airbag / Basic inspection / For frontal collision : When SRS is activated in a collision

CAUTION:
Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles.

WORK PROCEDURE

1. Before performing any of the following steps, ensure that all vehicle body and structural repairs have been completed.

2. Replace the diagnosis sensor unit.

3. Remove the front air bag modules, crash zone sensor, bracket and seat belt pre-tensioner assemblies.

4. Check the SRS components using the table below: Replace any SRS components showing visible signs of damage. (dents, cracks and deformation, etc.)
5. Install new front air bag modules, crash zone sensor assembly, bracket and seat belt pre-tensioner assemblies.

6. Perform self-diagnosis using CONSULT-III or air bag warning lamp. Refer to SRC-12, "Description" for details. Ensure entire SRS operates properly.

7. After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to SRC-12, "Description".

SRS INSPECTION (FOR FRONTAL COLLISION)


For frontal collision : When SRS is not activated in a collision


    Basic inspection
    COLLISION DIAGNOSIS ...

    For frontal collision : When SRS is not activated in a collision
    CAUTION: Due to varying models and option levels, not all parts listed in the chart below apply to all vehicles. WORK PROCEDURE 1. Before performing any of the following steps, ensure that all ...

    Other materials:

    Service Notice or Precautions for EPS System
    • Check the following item when performing the trouble diagnosis. - Check any possible causes by interviewing the symptom and it′s condition from the customer if any malfunction, such as EPS warning lamp is turned ON, occurs. - Check if air pressure and size of tires are proper, the spe ...

    Precaution for Brake System
    WARNING: Clean any dust from the front brake and rear brake with a vacuum dust collector. Never blow with compressed air. • Brake fluid use refer to MA-13, "Fluids and Lubricants". • Never reuse drained brake fluid. • Never spill or splash brake fluid on painted surfaces. Brake flui ...

    P173C 2GR incorrect ratio
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: • Be sure to perform “TM-447, "Diagnosis Procedure"” and then perform “DTC CONFIRMATION PROCEDURE”. • Never perform "DTC CONFIRMATION PROCEDURE" before the repairs. Doing so may result in a secondary ma ...