Nissan Juke Service and Repair Manual : Flushing

1. Install reservoir tank if removed and radiator drain plug.

CAUTION:
Be sure to clean drain plug and install with new O-ring.

Radiator drain plug : Refer to CO-42, "Exploded View".

• If water drain plugs on cylinder block are removed, close and tighten them. Refer to EM-228, "Disassembly and Assembly".

2. EM-161, "Exploded View"Remove air duct (between air cleaner case and electric throttle control actuator).

Refer to .

3. Disconnect heater hose (1) at position () in the figure.
) in the figure.

• Enhance heater as high as possible.: Vehicle front


• Enhance heater as high as possible.

4. Fill radiator and reservoir tank with water and reinstall radiator cap.


4. Fill radiator and reservoir tank with water and reinstall radiator cap.

• When engine coolant over flows disconnected heater hose, connect heater hose, and continue filling the engine coolant.

5. Install air duct (between air cleaner case and electric throttle control actuator). Refer to EM-161, "Exploded View".

6. Run the engine and warm it up to normal operating temperature.

7. Rev the engine two or three times under no-load.

8. Stop the engine and wait until it cools down.

9. Drain water from the system. Refer to CO-37, "Draining".

10. Repeat steps 1 through 9 until clear water begins to drain from radiator.

    Refilling
    1. Install reservoir tank if removed and radiator drain plug. CAUTION: Be sure to clean drain plug and install with new O-ring. Radiator drain plug : Refer to CO-42, "Exploded View". • ...

    Radiator
    ...

    Other materials:

    B2608 starter relay
    DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2608 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to BCS-83, "DTC Logic". • If DTC B2608 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to BCS-84, "D ...

    Diagnosis system (IPDM E/R)
    With intelligent key WITH INTELLIGENT KEY : Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp (only for K9K engine models) • Rear window defogger • F ...

    Hazard warning flasher switch
    Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights will flash. WARNING •  If stopping for an emergency, be sure to move the vehicle well off the road. •  Do not use the hazard warning flashers while moving on the ...