Nissan Juke Service and Repair Manual : Floor side fairing
Exploded View
1. Push spring nut
2. Floor under cover RH
3. Floor under cover LH
Removal and Installation
REMOVAL
FLOOR UNDER COVER
Remove floor under cover mounting nut and push spring nuts, and then remove floor under cover.
INSTALLATION
Install in the reverse order of removal.
Sill cover
Exploded View 1. Screw grommet 2. Screw grommet 3. Sill cover 4. Wind defle Removal and Installation REMOVAL 1. Remove sill cover front end fixing screw (A). 2. Remove sill cover rear en ...Fillet molding
Exploded View 1. Grommet 2. Clip 3. Clip 4. Front fillet molding 5. Rear fillet molding : Pawl : Do not reuse Front fillet molding FRONT FILLET MOLDING : Removal and Installation REMOVA ...Other materials:
B26F0 steering lock relay
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B26F0 is displayed with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to
BCS-83, "DTC Logic".
• If DTC B26F0 is displayed with DTC U1010, first perform the trouble diagnosis
for DTC U1010. Refer to
BCS-84, "D ...
Door lock and unlock switch
Component Function Check
1.CHECK FUNCTION
1. Select “DOOR LOCK” of “BCM” using CONSULT-III.
2. Select “CDL LOCK SW”, “CDL UNLOCK SW” in “DATA MONITOR” mode.
3. Check that the function operates normally according to the following
conditions.
Is the inspection result normal?
YES >> Doo ...
Towing your vehicle
When towing your vehicle, all State (Provincial in Canada) and local regulations
for towing must be followed. Incorrect towing equipment could damage your vehicle.
Towing instructions are available from a NISSAN dealer. Local service operators
are familiar with the applicable laws and procedur ...