Nissan Juke Owners Manual : Floor mats

WARNING

To avoid potential pedal interference that may result in a collision or injury:

• NEVER place a floor mat on top of another floor mat in the driver front position.

• Use only genuine NISSAN floor mats specifically designed for use in your vehicle model. See your NISSAN dealer for more information.

• Properly position the mats in the floorwell using the floor mat positioning aid. See “Floor mat positioning aid” .

The use of genuine NISSAN floor mats can extend the life of your vehicle carpet and make it easier to clean the interior. Mats should be maintained with regular cleaning and replaced if they become excessively worn.

Front (example)


Front (example)

Floor mat positioning aid

This model includes front floor mat brackets to act as floor mat positioning aid. NISSAN floor mats have been specially designed for your vehicle model. The front floor mats have grommet holes in them. To install, simply position the mat by placing the floor mat bracket through the floor mat grommet hole while centering the mat in the floorwell.

Periodically check to make certain that the mats are properly positioned.

Bracket positions


Bracket positions

The illustration shows the location of the floor mat brackets.

    Air fresheners
    Most air fresheners use a solvent that could affect the vehicle interior. If you use an air freshener, take the following precautions: • Hanging-type air fresheners can cause permanent discoloratio ...

    Seat belts
    The seat belts can be cleaned by wiping them with a sponge dampened in a mild soap solution. Allow the belts to dry completely in the shade before using them. See “Seat belts” . WARNING Do not al ...

    Other materials:

    Door motor
    Exploded View LEFT SIDE 1. A/C unit assembly 2. Intake door lever 3. Intake door motor 4. Air mix door motor 5. Upper air mix door rod 6. Upper air mix door lever 7. Lower air mix door lever 8. Lower air mix door rod RIGHT SIDE 1. A/C unit assembly 2. Main link 3. Sub defrost ...

    B2013 steering lock unit
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PERFORM DTC CONFIRMATION PROCEDURE 1. Lock the steering. NOTE: 3. Press the push-button ignition switch. 4. Check DTC in “Self Diagnostic Result” mode of “BCM” using CONSULT-III. Is DTC detected? YES >> Go to SEC-69, & ...

    Wiring diagram
    Engine control system Wiring Diagram For connector terminal arrangements, harness layouts, and alphabets in a (option abbreviation; if not described in wiring diagram), refer to GI-12, "Connector Information/Explanation of Option Abbreviation". ...