Nissan Juke Service and Repair Manual : Final drive
Exploded View
1. Shim
2. Differential side bearing outer race
(transaxle case side)
3. Differential side bearing inner race
(transaxle case side)
4. Final gear
5. Differential case
6. Differential side bearing inner race
(clutch housing side)
7. Differential side bearing outer race
(clutch housing side)
: Replace the parts as a set.
: N·m (kg-m, ft-lb)
Disassembly
1. Remove differential side bearing inner race (clutch housing side) (1), as per the following procedure.
a. Set a puller [Commercial service tool] to differential side bearing inner race (clutch housing side).
b. Remove differential side bearing inner race (clutch housing side), using the drift (A) [SST: ST33061000].
2. Remove final gear mounting bolts, and then remove final gear (1).
3. Remove differential side bearing inner race (transaxle case side) (1), as per the following procedure.
a. Set a puller [Commercial service tool] to differential side bearing inner race (transaxle case side).
b. Remove differential side bearing inner race (transaxle case side), using a drift (A) [Commercial service tool].
Assembly
1. Install final gear, and then tighten final gear mounting bolts to the specified torque.
CAUTION:
Replace final gear and differential case as a set.
2. Install differential side bearing inner race (clutch housing side), using a drift (A) [Commercial service tool].
CAUTION:
Replace differential side bearing inner race (clutch housing
side) and differential side bearing outer race (clutch housing
side) as a set.
3. Install differential side bearing inner race (transaxle case side), using a drift (A) [Commercial service tool].
CAUTION:
Replace differential side bearing inner race (transaxle case
side) and differential side bearing outer race (transaxle
case side) as a set.
Inspection
INSPECTION AFTER DISASSEMBLY
Gear and Case
Check final gear and differential case. Replace if necessary.
Bearing
Check bearing for damage and unsmooth rotation. Replace if necessary.
Reverse idler shaft and gear
Exploded View 1. Reverse output gear 2. Snap ring 3. Reverse baulk ring 4. Return spring 5. Needle bearing 6. Seal washer 7. Reverse idler shaft 8. Spacer 9. Reverse input gear 10. L ...Service data and specifications (SDS)
General Specifications ...Other materials:
Door sash tape
Exploded View
1. Front door panel
2. Front door sash tape
3. Rear door sash tape
4. Rear door panel
: Do not reuse
Front door sash tape
FRONT DOOR SASH TAPE : Removal and Installation
REMOVAL
Heat door sash tape surface using a dryer, and then peel door sash tape.
CAUTION:
Never dam ...
Primary speed sensor
Exploded View
1. Transaxle assembly
2. O-ring
3. Primary speed sensor
: Always replace after every
disassembly.
: N m (kg-m, in-lb)
: Genuine NISSAN CVT Fluid NS-2
Removal and Installation
REMOVAL
1. Remove the battery. Refer to PG-124, "Removal and Installation".
2. Remove ...
Component parts
Component Parts Location
LHD models
1. ABS actuator and electric unit (control
unit)
Refer to BRC-97, "Component Parts
Location".
2. ECM
Refer to EC-25, "ENGINE CONTROL
SYSTEM :
Component Parts Location".
3. Front wheel sensor
Refer to BRC-97, "Component Parts
...