Nissan Juke Service and Repair Manual : Fender protector
Exploded View
1. Hoodledge insurator
2. Fender protector
3. U nut
4. Air guide
5. Screw grommet
A. To hoodledge panel
: Vehicle front
Removal and Installation
REMOVAL
1. Remove front fillet molding. Refer to EXT-26, "FRONT FILLET MOLDING : Removal and Installation".
2. Remove air guide fixing bolts, and then remove air guide.
3. Remove front fender protector mounting screws and clips.
4. Remove front fender protector from wheel house.
INSTALLATION
Install in the reverse order of removal.
Cowl top
Exploded View LHD models 1. Front fender cover RH 2. Cowl top cover seal 3. Blind plug RH 4. Cowl top cover 5. Cowl top cover cap 6. Cowl top extension 7. EPT seal [t: 3.0 mm (0.118 in)] ...Sill cover
Exploded View 1. Screw grommet 2. Screw grommet 3. Sill cover 4. Wind defle Removal and Installation REMOVAL 1. Remove sill cover front end fixing screw (A). 2. Remove sill cover rear en ...Other materials:
Off-road recovery
If the right side or left side wheels leave the road surface, maintain control
of the vehicle by following the procedure below. Please note that this procedure
is only a general guide. The vehicle must be driven as appropriate based on the
conditions of the vehicle, road and traffic.
1. Remai ...
B27B0 A/C auto AMP.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC is displayed along with DTC U1000, first perform the trouble diagnosis
for DTC U1000. Refer to HAC-
141, "DTC Logic".
• If DTC is displayed along with DTC U1010, first perform the trouble diagnosis
for DTC U1010. HAC-142,
"DTC Log ...
Ignition position warning function does not operate
Diagnosis Procedure
1.CHECK DTC WITH BCM
Check that DTC is not detected with BCM.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Refer to BCS-67, "DTC Index".
2.CHECK POWER DOOR LOCK OPERATION
Check power door lock operation.
Does door lock/unlock with d ...