Nissan Juke Service and Repair Manual : Exploded View
M/T models
1. Clamp
2. Water hose
3. Oil cooler
4. Water hose
N·m (kg-m, in-lb)
CVT models
1. Clamp
2. Water hose
3. Oil cooler
4. Water hose
5. Water hose
6. Heater thermostat
7. Water hose
A. To CVT oil warmer
: N·m (kg-m, in-lb)
Removal and installation
OIL COOLER ...Removal and Installation
REMOVAL 1. Drain engine coolant. Refer to CO-11, "Draining". CAUTION: Perform when engine is cold. 2. Remove front bumper facia. Refer to EXT-12, "Exploded View". 3. Remove ...Other materials:
Removal and installation
IPDM E/R
Exploded View
1. IPDM E/R cover A
2. IPDM E/R
3. IPDM E/R cover B
Removal and Installation
CAUTION:
IPDM E/R integrated relays are not serviceable parts, and must not be removed
from the unit.
REMOVAL
1. Remove battery.
2. Press and expand pawls (A) on lateral side of IPDM E ...
P2118 throttle control motor
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF and wait at
least 10 seconds before conducting the next test.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
...
P0963 pressure control solenoid A
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PREPARATION BEFORE WORK
If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition
switch OFF and wait for at
least 10 seconds, then perform the next test.
>> GO TO 2.
2.CHECK DTC DETECTION
1. S ...