Nissan Juke Service and Repair Manual : Exploded View
1. Transfer gusset
2. Transfer assembly
3. Heat insulator
: Vehicle front
: N·m (kg-m, ft-lb)
Unit removal and installation
TRANSFER ASSEMBLY ...Removal and Installation
REMOVAL 1. Separate the rear propeller shaft. Refer to DLN-121, "Removal and Installation". 2. Remove right side drive shaft. Refer to FAX-24, "RIGHT SIDE : Removal and Installati ...Other materials:
Precaution for On Board Diagnosis (OBD) System of CVT and Engine
The ECM has an on board diagnostic system. It will light up the malfunction
indicator (MI) to warn the driver of
a malfunction causing emission deterioration.
CAUTION:
• Be sure to turn the ignition switch OFF and disconnect the battery cable from
the negative terminal
before any repair or ...
Wiring diagram
Engine control system
Wiring Diagram
For connector terminal arrangements, harness layouts, and alphabets in a
(option abbreviation; if not
described in wiring diagram), refer to GI-12, "Connector Information/Explanation
of Option Abbreviation".
...
P0730 incorrect gear ratio
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
NOTE:
If “DTC CONFIRMATION PROCEDURE” has been previously performed, always turn
ignition switch
OFF and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the mal ...