Nissan Juke Service and Repair Manual : Exhaust valve timing control

Exhaust valve timing control : System Diagram

Exhaust valve timing control: System Description


Exhaust valve timing control: System Description

INPUT/OUTPUT SIGNAL CHART

SYSTEM DESCRIPTION


SYSTEM DESCRIPTION

This mechanism hydraulically controls cam phases continuously with the fixed


This mechanism hydraulically controls cam phases continuously with the fixed operating angle of the exhaust valve.

The ECM receives signals such as crankshaft position, camshaft position, engine speed, and engine oil temperature.

Then, the ECM sends ON/OFF pulse duty signals to the exhaust valve timing (EVT) control solenoid valve depending on driving status. This makes it possible to control the shut/open timing of the exhaust valve to increase engine torque and output in a range of high engine speed.

    Intake valve timing control
    Intake valve timing control : System Diagram Intake valve timing control : System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION This mechanism hydraulically controls cam phases co ...

    Turbocharger boost control
    Turbocharger boost control : SystemDiagram Turbocharger boost control : System Description INPUT/OUTPUT SIGNAL CHART SYSTEM DESCRIPTION Depending on driving conditions, the ECM performs ON/OFF ...

    Other materials:

    Brake booster
    Exploded View 2WD 1. Master cylinder assembly 2. Vacuum pipe 3. Brake booster 4. Lock nut 5. Clevis 6. Gasket 7. Spacer : N·m (kg-m, ft-lb) 4WD 1. Master cylinder assembly 2. Brake booster 3. Lock nut 4. Clevis 5. Gasket 6. Spacer : N·m (kg-m, ft-lb) Removal and install ...

    P1804, P1809 4WD control module
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.DTC REPRODUCTION PROCEDURE With ...

    Hazard reminder operation does not operate
    Diagnosis Procedure 1.CHECK DTC WITH BCM AND COMBINATION METER Check that DTC is not detected with BCM and combination meter. Is the inspection result normal? YES >> GO TO 2. NO-1 >> Refer to BCS-141, "DTC Index". (BCM) NO-2 >> Refer to MWI-36, "DTC Index&q ...