Nissan Juke Service and Repair Manual : Exhaust manifold

Exploded View

1. Exhaust gas temperature sensor 1


1. Exhaust gas temperature sensor 1 2. Gasket
3. Exhaust manifold
4. Exhaust gas pressure sensor 1

A. To cylinder head

: Always replace after every: N·m (kg-m, ft-lb)
disassembly.: Always replace after every
disassembly.

Removal and Installation

REMOVAL

1. Remove turbocharger assembly. Refer to EM-284, "Exploded View".

2. Loosen exhaust manifold mounting nuts in the reverse order as shown.

3. Remove exhaust manifold.


3. Remove exhaust manifold.

INSTALLATION

1. Tighten the mounting nuts in numerical order as shown.

2. Install in reverse order of removal after this step.


2. Install in reverse order of removal after this step.

Inspection

Start engine and raise engine speed to check no exhaust emission leaks.

    Turbocharger
    Exploded View 1. Exhaust manifold 2. Turbocharger 3. Gasket 4. Turbocharger outlet duct 5. Oil outlet hose 6. Clamp 7. Oil return pipe 8. Gasket 9. Washer 10. Oil supply tube 11. O ...

    Oil pan
    Exploded View 1. Baffle plate 2. Gasket 3. Oil pan 4. O-ring 5. Drain plug 6. Oil level gauge guide 7. Transaxle 8. Crankshaft position sensor (POS) : N·m (kg-m, ft-lb) : N·m (kg-m, i ...

    Other materials:

    Precaution Necessary for Steering Wheel Rotation after Battery Disconnect
    NOTE: • Before removing and installing any control units, first turn the ignition switch to the LOCK position, then disconnect both battery cables. • After finishing work, confirm that all control unit connectors are connected properly, then re-connect both battery cables. • Always use CONS ...

    C1120, C1122, C1124, C1126 ABS in valve system
    DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test. >> GO TO 2. 2.CHECK DTC DETECTION With CONSULT ...

    Overspeed at idle speed or on releasing brake
    Description CHART 14: OVERSPEED AT IDLE SPEED OR ON RELEASING BRAKE Diagnosis Procedure 1.CHECK ENGINE OIL Check the grade of engine oil. Refer to LU-33, "Inspection". Is the inspection result normal? YES >> GO TO 2. NO >> Replace engine oil. Refer to LU-34, "Re ...