Nissan Juke Service and Repair Manual : Except for M/T models
Except for M/T models : Description
ECM receives a G sensor signal from TCM via CAN communication to switch combustion for the direct injection gasoline system. For the direct injection gasoline system, refer toEC-48, "DIRECT INJECTION GASOLINE SYSTEM : System Description".
Except for M/T models : DTC Logic
DTC DETECTION LOGIC
NOTE
:
• If DTC P159A, P159C or P159D is displayed with DTC UXXXX, first perform the
trouble diagnosis for DTC
UXXXX. Refer to EC-108, "DTC Index".
• If DTC P159A, P159C or P159D is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to EC-304, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.
TEST CONDITION:
Before performing the following procedure, confirm that battery voltage is more
than 11 V at idle.
>> GO TO 2.
2.PERFORM DTC CONFIRMATION PROCEDURE
1. Start engine and let it idle for at least 5 seconds.
2. Check 1st trip DTC.
Is 1st trip DTC detected? YES >> Proceed to EC-359, "EXCEPT FOR M/T MODELS : Diagnosis Procedure".
NO >> INSPECTION END
Except for M/T models : Diagnosis Procedure
1.CHECK DTC WITH TCM
With CONSULT-III
Check DTC with TCM. Refer to TM-159, "CONSULT-III Function (TRANSMISSION)".
Is the inspection result normal? YES >> GO TO 2.
NO >> Perform Diagnosis Procedure corresponding to DTC indicated.
2.PERFORM DIAGNOSIS PROCEDURE OF G SENSOR
Perform Diagnosis Procedure of G sensor. Refer to TM-236, "Diagnosis Procedure".
Is the inspection result normal? YES >> INSPECTION END
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
P159A, P159C, P159D G sensor
For M/T models : DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure ...P159B G sensor
For M/T models : DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE 1.PRECONDITIONING If DTC Confirmation Procedure has been previously conducted, always perform the following procedure ...Other materials:
Electric foldable door mirror does not operate
Diagnosis Procedure
1.CHECK DOOR MIRROR (OPEN/CLOSE MOTOR) CIRCUIT
Check door mirror (open/close motor) circuit.
Refer to MIR-25, "Component Function Check".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace the malfunctioning parts.
2.CONF ...
Control panel buttons — color screen with navigation system (if so equipped)
1. (brightness control) button
2. Display screen
3. MAP button
4. NAV button
5. TRAF button
6. SETUP button
7. BACK button
8. TUNE/SCROLL knob
9. Power button/Volume control knob
For navigation system control buttons, refer to the separate Navigation System
Owner’s Manual.
When ...
A-bag branch line circuit
Diagnosis Procedure
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative
terminal, and wait 3 minutes
or more. (To discharge backup capacitor.)
• Never use unspecified tester or other measuring device.
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disco ...