Nissan Juke Service and Repair Manual : ESP warning lamp
Component Function Check
1.CHECK ESP WARNING LAMP FUNCTION
Check that ESP warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON.
CAUTION:
Never start engine.
Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to diagnosis procedure. Refer to BRC-214, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit.
Refer to BRC-205, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace error-detected parts.
2.PERFORM THE SELF-DIAGNOSIS
With CONSULT-III.
Perform self-diagnosis for “ABS”.
Is any DTC detected? YES >> Check the DTC. Refer to BRC-142, "DTC Index".
NO >> GO TO 3.
3.CHECK ESP WARNING LAMP SIGNAL
With CONSULT-III.
1. Select “ABS”, “DATA MONITOR” and “SLIP/VDC LAMP” according to this order.
2. Turn the ignition switch OFF.
3. Check that data monitor displays “On” for approx. 1 second after ignition switch is turned ON, and then changes to “Off”.
CAUTION:
Never start engine.
Is the inspection result normal? YES >> Check combination meter. Refer to MWI-23, "CONSULT-III Function".
NO >> Replace ABS actuator and electric unit (control unit). Refer to BRC-233, "Removal and Installation".
Brake warning lamp
Component Function Check 1.CHECK BRAKE WARNING LAMP FUNCTION (1) Check that brake warning lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CAUTION: ...ESP off indicator lamp
Component Function Check 1.CHECK ESP OFF INDICATOR LAMP FUNCTION (1) Check that ESP OFF indicator lamp in combination meter turns ON for approx. 1 second after ignition switch is turned ON. CA ...Other materials:
B1183 lap Pre-tensioner LH
DTC Logic
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp status. Refer to SRC ...
Service Notice or Precautions for Steering System
• In case of removing steering gear assembly, make the final tightening with
grounded and unloaded vehicle
condition, and then check wheel alignment.
• Observe the following precautions when disassembling.
- Before disassembly, thoroughly clean the outside of the unit.
- Disassembly should b ...
Side air bag (satellite) sensor
Exploded View
1. Satellite sensor
: Vehicle front
: Do not reuse
: N·m (kg-m, ft-lb)
Removal and Installation
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative
terminal and wait 3 minutes
or more.
• Never use the air tools or electric tools for servicing ...