Nissan Juke Service and Repair Manual : ESP off switch
Removal and Installation
REMOVAL
1. Remove lower instrument panel. Refer to IP-13, "Removal and Installation".
2. Remove ESP OFF switch.
INSTALLATION
Installation is the reverse order of removal.
Steering angle sensor
Removal and Installation REMOVAL 1. Remove spiral cable assembly. Refer to SR-16, "Removal and Installation". 2. Remove steering angle sensor. INSTALLATION Note the following, and i ...Steering System
...Other materials:
Unit removal and installation
Engine assembly
Exploded View
1. Engine torque rod
2. Engine mounting insulator
3. Engine mounting stay
4. Transaxle mounting stay
5. Engine mounting rear bracket
6. Transaxle torque rod
7. Transaxle mounting upper bracket
8. Transaxle mounting insulator
: Vehicle front
: N·m (kg- ...
B1130 side air bag module RH
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAG RESULT
With CONSULT-III
1. Turn ignition switch ON.
2. Perform “Self Diagnostic Result” mode of “AIR BAG” using CONSULT-III.
Without CONSULT-III
1. Turn ignition switch ON.
2. Check the air bag warning lamp statu ...
Removal and Installation Procedure for CVT Unit Connector
REMOVAL
• Rotate bayonet ring (A) counterclockwise. Pull out CVT unit harness
connector (B) upward and remove it.
INSTALLATION
1. Align marking (A) on CVT unit harness connector terminal with
marking (B) on bayonet ring. Insert CVT unit harness connector.
2. Rotate bayonet ring clockwise.
...