Nissan Juke Service and Repair Manual : Engine unit

Disassembly

1. Remove intake manifold. Refer to EM-28, "Exploded View".

2. Remove catalyst convertor. Refer to EM-33, "2WD : Exploded View" (2WD models) or EM-34, "4WD : Exploded View" (4WD models).

3. Remove turbocharger. Refer to EM-36, "Exploded View".

4. Remove exhaust manifold. Refer to EM-38, "Exploded View".

5. Remove oil pan (lower). Refer to EM-99, "Exploded View".

6. Remove ignition coil, spark plug, and rocker cover. Refer to EM-23, "Exploded View".

7. Remove fuel injector and fuel tube. Refer to EM-47, "Exploded View".

8. Remove timing chain. Refer to EM-67, "Exploded View".

9. Remove camshaft. Refer to EM-78, "Exploded View".

10. Remove water inlet. Refer to CO-24, "Exploded View".

11. Remove water outlet. Refer to CO-26, "Exploded View".

12. Remove cylinder head. Refer to EM-90, "Exploded View".

Assembl

Assemble in the reverse order of disassembly.

    Engine stand setting
    Setting NOTE: Explained here is how to disassemble with engine stand supporting transaxle surface. When using different type of engine stand, note with difference in steps and etc. 1. Remove t ...

    Drive belt auto tensioner and idler pulley
    Exploded View 1. Front cover 2. Drive belt auto-tensioner : Nm (kg-m, ft-lb) Removal and Installation Removal 1. Loosen mounting bolt and remove drive belt auto-tensioner. Installation I ...

    Other materials:

    Cockpit
    1. Outside mirror remote control switch 2. Headlight, fog light and turn signal switch Headlight Turn signal light Fog light 3. Steering wheel Electric power steering system Horn Drivers supplemental air bag 4. Wiper and washer switch 5. Shift lever Continuously Variable ...

    Refrigerant
    Description CONNECTION OF SERVICE TOOLS AND EQUIPMENT 1. Shut-off valve 2. A/C service valve 3. Recovery/recycling/recharging equipment 4. Vacuum pump 5. Manifold gauge set 6. Refrigerant container (HFC-134a) 7. Weight scale A. Preferred (best) method B. Alternative method C. For ...

    Erratic acceleration
    Description CHART 10: Erratic acceleration Diagnosis Procedure 1.CHECK ECM POWER SUPPLY AND GROUND CIRCUIT Check ECM power supply and ground circuit. Refer to EC-885, "Diagnosis Procedure". Is the inspection result normal? YES >> GO TO 2. NO >> Repair or replace ha ...